Knowledge Base
/

Working with Control Point Settings

Updated May 20, 2021 1 min read

In FlowStation App, you can add or update the following control point settings:

Note

Any changes that you make in FlowStation App are automatically copied to the associated BaseStation 3200 irrigation controller(s), to BaseManager (if subscribed), and to the FlowStation.

  • The control point description

  • Whether the control point is enabled or disabled

  • Enable and define the control point group for that control point which allows the FlowStation to activate the control point with the smallest GPM in that group to supply water for downstream zones based on their requested GPM

  • The target flow of the control point

  • High and unscheduled flow limits and whether or not to shut down if the flow limit is exceeded

  • High and low pressure limits and whether or not to shut down if the pressure limit is exceeded

  • Devices assigned to that control point, including:

    • Edit a flow sensor description

    • Enable or disable a flow sensor

    • Define the K-value for the flow sensor

    • Edit a master valve description

    • Enable or disable a master valve

    • Define whether the master valve is normally open

Refer to the topics within this section for specific instructions.

Was this article helpful?

Related in Hydraulic Settings.

  1. Setting the Mainline to be Managed by Flow What is Manage by Flow? Manage by flow is a feature in BaseManager that optimizes the number of stations that
  2. Setting Up a Control Point Group With a FlowStation, you can use the Control Point Group feature. When you put control points into a group, the
  3. Updating a Mainline Description 1.  On the main FlowStation App page, click the FlowStation where the mainline that you want to work with is
  4. Working with Water Source Settings In FlowStation App, you can add or update the following water source settings: Note Any changes that you make in