Knowledge Base
/

Working with Water Source Settings

Updated May 20, 2021 1 min read

In PipeView, you can add or update the following water source settings:

Note

Any changes that you make in PipeView are automatically copied to the associated BaseStation 3200 irrigation controller(s), to BaseManager (if subscribed), and to the FlowStation (if applicable).

  • The description of the water source
  • Whether the water source is enabled or disabled
  • The water source priority level
  • The monthly water budget
  • Whether the water source will shut down if it meets or exceeds the water budget
  • Empty conditions for the water source


Refer to the topics within this section for specific instructions.

Was this article helpful?

Related in Hydraulic Settings.

  1. Updating Details for Control Point Devices You can update the details for the flow meter, master valve, and/or pressure sensor that are assigned to a
  2. Updating a Mainline Description 1.  In PipeView position the hydraulic system diagram so you can see the mainline that you want to work with
  3. Updating a Zone Description 1.  In PipeView position the hydraulic system diagram so you can see the zone (valve) that you want to work
  4. Setting Limits for a Control Point 1.  In PipeView position the hydraulic system diagram so you can see the control point that you want to work