Knowledge Base
/

Working with Zone Settings

Updated May 20, 2021 1 min read

In PipeView, you can add or update the following zone settings:

Note

Any changes that you make in PipeView are automatically copied to the associated BaseStation 3200 irrigation controller(s), to BaseManager (if subscribed), and to the FlowStation (if applicable).

  • The zone description

  • Enable or disable the zone

  • The design flow for that zone

Refer to the topics within this section for specific instructions.

Was this article helpful?

Related in Hydraulic Settings.

  1. Updating a Zone Description 1.  In PipeView position the hydraulic system diagram so you can see the zone (valve) that you want to work
  2. Updating a Mainline Description 1.  In PipeView position the hydraulic system diagram so you can see the mainline that you want to work with
  3. Updating Details for Control Point Devices You can update the details for the flow meter, master valve, and/or pressure sensor that are assigned to a
  4. Setting the Monthly Water Budget 1.  In PipeView position the hydraulic system diagram so you can see the water source that you want to work