Baseline status codes

Use this guide to help identify baseline status codes for potential errors.

1.1 Status Codes – Remote Units

HEX	DEC	Code	Description
0x01	001	Success/OK	Success
0x40	064	Over Current	Valve current limit exceeded: less than ‘50’ count for ~100 ms.
0x41	065	Short Circuit	Valve current limit exceeded: less than ‘50’ count in 2 ms.
0x42	066	Open circuit	No measurable valve current: greater than ‘220’ in 2 ms.
0x43	067	I2C Error	Communication error with I2C device (EEPROM, …)
0x44	068	Illegal Command	Unknown command.
0x45	069	Command Rejected	Unable to do command (attempted to write to EEPROM without an unlock first).
0x46	070	Partial Reading	A read water rate command returned with a fractional minute reading (powered up less than one minute).
0x47	071	Framing Error	Remote unit incoming packet has bad preamble (frame error)
0x48	072	Limit Exceeded	Returned when the water flow rate limit is exceeded.
0x49	073	Ports Exceeded	Attempting to actuate too many valve ports on a multi-valve decoder.
0x4A	074	Low Startup Voltage	The valve actuate voltage during step 1 of a valve actuation has dropped to less than 12 volts.
0x4B	075	Data Ready	The remote device has data available that needs attention (pause button pressed, button control box keys, …).
0x4C	076	Below Lower Limit	Returned when the pressure has fallen below the lower limit.
0x4D	077	Data Overflow	A data sequence from a remote unit has overflowed…either numeric or data stream.
0x4E	078	No AC Voltage	The 24 VAC supply is not available on the 12-Valve AC Decoder.
0x80		ERR_TWIG	The radio TWIG has an error (Nelson)