Knowledge Base
/

How to change the IOT URL for a 3200S

Updated April 11, 2025 1 min read

*This can only be used for Tier 2. Please reach out to Tier 2 with the Company/ Site/ Controller information.

*this command is only for 3200S controllers 

  1. set,io, ip = iot.baselineapps.net
  2. get,io - Inquiry to see what IOT address is or confirm that change went through
Was this article helpful?

Related in Programming.

  1. Turning Electricity On/Off with a Program Update Table of Contents Required MaterialsOverview of the StepsStep 1 - Installing the Dayton RelayStep 2 - Installing the biCoderStep
  2. Setting Up Water Source Priorities With Baseline’s BaseStation 3200 irrigation controller, you can use water from multiple sources to run your irrigation programs. When
  3. Stopping Irrigation for Rain Events If an irrigation system that you manage is running during a rain storm, your customer might be criticized for wasting
  4. SubStation Quick Start Guides See the attached documents below when referencing the Quick Start Guides for the various models of SubStation depending on the